sof file, open the clock control and change the target frequency setting asģ. d.Type the command “EN_AVALON_ST_LOOPBACK” to enable the Avalon ST loopback moduleġ.Download the altera_eth_10g_mac_base_kr_top.sof file provided into Stratix V SI Board B.Ģ. Type the command “source demo.tcl “ followed by ENTER key to launch the reference design command list. Browse to the DEMO directory in the System Console command shell. Launch system console: open QSYS Tools System Console b. (After hard reset, the Ethernet is in 10G mode).Ĥ. If user connects the SFP+ module with SFP optical loopback cable, user should expect to see LED 7 and LED 8 will LIT as System must be hard reset before proceed. Press PB0 push button to reset the system. sof file, open the clock control and change the target frequency setting as below (refer to Figure 4 and Figure 5):ģ. SV Transceiver Signal Integrity Development Kit Hardware setupĭownload and unzip the demo project: File:Single port 1G 10G hardware demo.zip for Quartus II 12.1ġ.Download the altera_eth_10g_mac_base_kr_top.sof file provided into Stratix V SI Board A.Ģ.
#1gb loopback cable install#
■Ĝlock control ( refer to to install the Kit installation for v11.1.2 ) ■ğinisar SFP+ (FTLX8571D3BCV) optical cable. ■Ē Stratix V SI hardware kits (5SGXEA7N2CF40C2) The following sections describe tool requirements for the hardware demo.
#1gb loopback cable generator#
Internal traffic generator module has been included in the design to generate either a fixed /random packets data and there is a traffic monitor module to check for the data received and calculate for the throughput to indicate the changes in speed of the 1G/10Gbps IP. Two Stratix V SI hardware kits will be used for the demo: Board B which generate packets data to Board A through SFP+ module(FTLX8571D3BCV) and loopback at Avalon ST interface of Board A and then the data will be received back by Board B. This note describes a demo design that demonstrates the functionality of the Altera 1G/10Gbps Ethernet IP which able to switch from 1G to 10Gbps speed and vice versa for both manual and automatic mode.
0 kommentar(er)
